Transmission Control Switch Circuit
Circuit diagnosis · Vehicles built from Oct 2006
DESCRIPTION
When moving the shift lever into the S position using the transmission control switch, it is possible to switch the shift range position between "1" (first range) and "6" (sixth range).Shifting up "+" once raises one shift range position, and shifting down "-" lowers one shift range position.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (BATTERY - TRANSMISSION CONTROL SWITCH) |
Disconnect the transmission control switch connector of the shift lock control unit assembly.

Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Switch Condition
Tester Connection
Specified Condition
Ignition switch on (IG)
E31-3 - Body ground
10 to 14 V
Ignition switch off
Below 1 V
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (TRANSMISSION CONTROL SWITCH - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Specified Condition
E31-5 - Body ground
Below 1 Ω
|
|
||||
| OK | |
| 3. INSPECT TRANSMISSION CONTROL SWITCH |
Measure the resistance between each terminal of the shift lock control unit assembly when the shift lever is moved to each position.

- Standard resistance:
Shift Position
Tester Connection
Specified Condition
S, "+" and "-"
E31-3 - E31-7
Below 1 Ω
Except S, "+" and "-"
10 kΩ or higher
Press continuously
"+"
(Up shift)
E31-2 - E31-5
Below 1 Ω
S
10 kΩ or higher
Press continuously
"-"
(Down shift)
E31-1 - E31-5
Below 1 Ω
S
10 kΩ or higher
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (TRANSMISSION CONTROL SWITCH - ECM) |
Connect the transmission control switch connector of the shift lock control unit assembly.

Disconnect the A24*1 or A55*2 ECM connector.
Turn the ignition switch on (IG), and measure the voltage according to the value(s) in the table below when the shift lever is moved to each position.
- Standard voltage:
Shift Position
Tester Connection
Specified Condition
S, "+" and "-"
A24-25*1 (S) - Body ground
A55-25*2 (S) - Body ground
10 to 14 V
Except S, "+" and "-"
Below 1 V
Turn the ignition switch off.
Disconnect the ECM connector.*1: for RHD*2: for LHD
Measure the resistance according to the value(s) in the table below when the shift lever is moved to each position.
- Standard resistance:
Shift Position
Tester Connection
Specified Condition
Press continuously
"+"
(Up shift)
A24-16*1 (SFTU) - Body ground
A55-16*2 (SFTU) - Body ground
Below 1 Ω
S
10 kΩ or higher
Press continuously
"-"
(Down shift)
A24-51*1 (SFTD) - Body ground
A55-51*2 (SFTD) - Body ground
Below 1 Ω
S
10 kΩ or higher
|
|
||||
| OK | ||
| ||
