2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

AFS OFF Switch Circuit

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

When the AFS switch is pushed (ON), the AFS ECU will cancel the intelligent AFS control and turn on the AFS OFF indicator light.

WIRING DIAGRAM

B110609E15

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the intelligent tester main switch on.

  1. Select the item below in the DATA LIST, and read its value displayed on the intelligent tester.

    AFS (AFS ECU): 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    AFS OFF SW
    AFS OFF switch signal ON / OFF
    ON: AFS OFF switch pushed
    OFF: AFS OFF switch not pushed
    -



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2. INSPECT AFS OFF SWITCH

HINT:
(Click here)



NG
REPLACE AFS OFF SWITCH
OK


3. CHECK HARNESS AND CONNECTOR (AFS OFF SWITCH - AFS ECU AND BODY GROUND)

  1. E133314E04
    Disconnect the A61 AFS ECU connector.

  1. Disconnect the E69 or E98 AFS OFF switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A61-32 (MSW) - E69-4 or E98-4
    Always
    Below 1 Ω
    E69-1 or E98-1 - Body ground
    Always
    Below 1 Ω
    A61-32 (MSW) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AFS ECU


← AFS ECU Power Source Circuit (from Oct 2006)Headlight Beam Level Warning Circuit (Oct 2006 – May 2009) →