2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

AFS ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

This circuit detects the state of the ignition switch. The AFS ECU receives it from the ignition switch.

WIRING DIAGRAM

E133243E02

INSPECTION PROCEDURE


1. INSPECT FUSE (ECU-IG NO. 2 OR H-LP LVL)
  1. Remove the ECU-IG No. 2 fuse or H-LP LVL fuse from the instrument panel junction block assembly.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2. INSPECT AFS ECU

  1. E133228E04
    Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A61-14 (IGS) - A61-22 (EIS)
    Ignition switch off
    Below 1 V
    Ignition switch on (IG)
    10 to 14 V
    A61-15 (IGSR) - A61-22 (EIS)
    Ignition switch off
    Below 1 V
    Ignition switch on (IG)
    10 to 14 V



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


3. CHECK WIRE HARNESS (AFS ECU - BATTERY AND BODY GROUND)

  1. E133227E04
    Disconnect the A61 AFS ECU connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A61-14 (IGS) - Body ground
    Ignition switch on (IG)
    10 to 14 V
    A61-15 (IGSR) - Body ground
    Ignition switch on (IG)
    10 to 14 V

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A61-22 (EIS) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AFS ECU


← Headlight Beam Level Control Actuator Circuit (Oct 2006 – May 2009)AFS OFF Switch Circuit (from Oct 2006) →