Rear Sunshade Shift-linked Function does not Operate when Shift Lever is Moved to R Position
Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
SYSTEM DESCRIPTION
When the ignition switch is ON position and rear sunshade is raised, moving the shift lever to R position causes the park/neutral position switch (A/T) or back-up light switch (M/T) to send a reverse-linked signal to the rear sunshade relay. The relay then lowers the rear sunshade.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK OPERATION |
Check that the back-up light comes on when the shift lever is moved to the R position.
- OK:
- Back-up light comes on when shift lever is moved to the R position.
|
|
||||
| OK | |
| 2. CHECK WIRE HARNESS (REAR SUNSHADE RELAY - PARK/NEUTRAL POSITION SWITCH) |
Disconnect the N41 connector.

Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester connection
Condition
Specified condition
REV (N41-2) - Body ground
Ignition switch ON, shift lever not in R
Below 1 V
REV (N41-2) - Body ground
Ignition switch ON, shift lever in R
10 to 14 V
|
|
||||
| OK | |
| 3. INSPECT REAR SUNSHADE MOTOR |
![]() ![]() |
Disconnect the N42 connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester connection
Specified condition
N42-1 - N42-2
Below 1 Ω
N42-1 - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 4. CHECK WIRE HARNESS (REAR SUNSHADE MOTOR - REAR SUNSHADE RELAY) |
Disconnect the N42 and N41 connectors.

Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester connection
Specified condition
N42-1 - MOP (N41-9)
Below 1 Ω
N42-2 - MCL (N41-10)
Below 1 Ω
MOP (N41-9) - Body ground
10 kΩ or higher
MCL (N41-10) - Body ground
10 kΩ or higher
|
|
||||
| OK | ||
| ||

