2006-2011 Camry Aurion · Service Manual ENGINE

B2287 LIN Communication Master Malfunction

Diagnostic trouble codes · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

This DTC is output when there is a LIN communication problem between the main body ECU and certification ECU.

HINT:
When the main body ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU or certification ECU is replaced, perform the registration procedures for the engine immobiliser system.

DTC No.
DTC Detection Condition
Trouble Area
B2287
Communication or communication line is abnormal between the main body ECU and the certification ECU
  1. Main body ECU
  2. Certification ECU
  3. Wire harness or connector
B137997E03

WIRING DIAGRAM

B137989E07

INSPECTION PROCEDURE


1. CHECK FOR DTCS
  1. Delete the DTCs (Click here).

  1. Check for DTC B2287 (LIN communication master malfunction) and B2785 (Communication malfunction between ECUs connected by LIN).

    Result:
    Display (DTC output)
    Proceed to
    "DTC B2287" only
    A
    "DTC B2287" and "DTC B2785"
    B
    No DTC
    C

    HINT:
    If DTC B2785 is output, perform troubleshooting for DTC B2785 first (Click here).



B
GO TO DTC B2785 (Click here)

C
CHECK INTERMITTENT PROBLEMS
A


2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - CERTIFICATION ECU)

  1. Disconnect the E58 and IR ECU connectors.B161016E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    IR-9 (LIN1) - E58-10 (LIN)
    Always
    Below 1 Ω
    IR-9 (LIN1) or E58-10 (LIN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK MAIN BODY ECU OPERATION
  1. After replacing the main body ECU with a normally functioning ECU, check that the engine starts (Click here).

    OK:
    Engine can start normally.



NG
REPLACE CERTIFICATION ECU
OK

END (MAIN BODY ECU DEFECTIVE)


← B2286 Runnable Signal Malfunction (from Jun 2009)B2287 LIN Communication Master Malfunction (from Jun 2009) →