B2287 LIN Communication Master Malfunction
Diagnostic trouble codes · Vehicles built from Jun 2009
DESCRIPTION
This DTC is output when there is a LIN communication problem between the main body ECU and certification ECU.- HINT:
- When the main body ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
- After the main body ECU or certification ECU is replaced, perform the registration procedures for the engine immobiliser system.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2287 |
Communication or communication line is abnormal between the main body ECU and the certification ECU |
|


WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK FOR DTCS |
Delete the DTCs (Click here).
Check for DTC B2287 (LIN communication master malfunction) and B2785 (Communication malfunction between ECUs connected by LIN).
- Result:
Display (DTC output)
Proceed to
"DTC B2287" only
A
"DTC B2287" and "DTC B2785"
B
No DTC
C
- HINT:
- If DTC B2785 is output, perform troubleshooting for DTC B2785 first (Click here).
|
|
||||
|
|
||||
| A | |
| 2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - CERTIFICATION ECU) |
Disconnect the E58 and IR instrument panel junction block connectors.


Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
IR-9 (LIN1) - E58-10 (LIN)
Always
Below 1 Ω
IR-9 (LIN1) or E58-10 (LIN) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 3. CHECK MAIN BODY ECU OPERATION |
After replacing the main body ECU with a normally functioning ECU, check that the engine starts (Click here).
- OK:
- Engine can start normally.
|
|
||||
| OK | ||
| ||
