2006-2011 Camry Aurion · Service Manual RESTRAINTS

CHECK MODE PROCEDURE

Troubleshooting · Vehicles built from Oct 2006

Versions by build date: Jun 2006 – Sep 2006 from Oct 2006


CHECK MODE (SIGNAL CHECK): DTC CHECK

  1. B139188E10
    Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Select "SIGNAL CHECK", and proceed with checking using the intelligent tester.

    NOTICE:
    Select "SIGNAL CHECK" from the "DTC CHECK" screen displayed on the intelligent tester to clear the output DTCs (both present and past).

    HINT:
    1. DTCs can be detected more sensitively in check mode than in normal diagnosis mode.
    2. Perform check mode inspection when a malfunction in each squib circuit is suspected even after the normal system code is output through normal diagnosis mode inspection.

← CHECK MODE PROCEDURE (Jun 2006 – Sep 2006)DATA LIST / ACTIVE TEST (Jun 2006 – Sep 2006) →