C1246/46 Master Cylinder Pressure Sensor Malfunction
Diagnostic trouble codes · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
The master cylinder pressure sensor is connected to the skid control ECU in the brake actuator assembly.

| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1246/46 |
When any of the following is detected:
|
|
INSPECTION PROCEDURE
- HINT:
- Check the condition of each related circuit connector before troubleshooting (Click here).
| 1. CHECK STOP LIGHT OPERATION |
Check that the stop light comes on when the brake pedal is depressed, and goes off when the brake pedal is released.
- OK:
Condition
Illumination Condition
Brake pedal depressed
ON
Brake pedal released
OFF
|
|
||||
| OK | |
| 2. READ VALUE USING INTELLIGENT TESTER (MASTER CYLINDER PRESSURE SENSOR) |
Connect the intelligent tester to the DLC3.
Start the engine.
Select the "Data List" mode on the intelligent tester (Click here).
Data List: ABS/TRC/VSC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Master Cylinder Sensor
Master cylinder pressure sensor 1 reading / Min.: 0 V, Max.: 5 V
When brake pedal is released: 0.3 to 0.5 V
-
Check that the hydraulic pressure value of the master cylinder pressure sensor observed on the intelligent tester changes when the brake pedal is depressed.
- OK:
- When the pedal is depressed, voltage displayed on the intelligent tester increases.
|
|
||||
| OK | |
| 3. READ VALUE USING INTELLIGENT TESTER (STOP LIGHT SWITCH) |
Select the "Data List" mode on the intelligent tester (Click here).
Data List: ABS/TRC/VSC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Stop Lamp SW
Stop light switch / ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
-
Check that the stop light condition observed on the intelligent tester changes when the brake pedal is depressed.
- OK:
- When the brake pedal is depressed, the intelligent tester displays "ON".
|
|
||||
| OK | |
| 4. RECONFIRM DTC |
Clear the DTCs (Click here).
Start the engine.
At a speed of 30 km/h (18 mph) or more, drive the vehicle and perform braking test (decelerate the vehicle by depressing the brake pedal).
Check if the same DTC is recorded (Click here).
- HINT:
- Reinstall the sensors, connectors, etc. and restore the vehicle to its prior condition before rechecking for DTCs.
- Result:
Result
Proceed to
DTC (C1246/46) is not output
A
DTC (C1246/46) is output
B
|
|
||||
| A | ||
| ||
