C1246/46 Master Cylinder Pressure Sensor Malfunction
Diagnostic trouble codes · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
The master cylinder pressure sensor is connected to the skid control ECU in the brake actuator assembly.

| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1246/46 |
Any of the following is detected:
|
|
INSPECTION PROCEDURE
- HINT:
- Check the condition of each related circuit connector before troubleshooting (Click here).
| 1. CHECK STOP LIGHT OPERATION |
Check that the stop light comes on when the brake pedal is depressed, and goes off when the brake pedal is released.
- OK:
Condition
Illumination Condition
Brake pedal depressed
ON
Brake pedal released
OFF
|
|
||||
| OK | |
| 2. READ VALUE USING INTELLIGENT TESTER (MASTER CYLINDER PRESSURE SENSOR) |
Connect the intelligent tester to the DLC3.
Start the engine.
Select the "Data List" mode on the intelligent tester (Click here).
Data List: ABS/TRC/VSC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Master Cylinder Sensor
Master cylinder pressure sensor 1 reading / Min.: 0 V, Max.: 5 V
When brake pedal is released: 0.1 to 0.9 V
Reading increases when brake pedal is depressed
Check that the hydraulic pressure value of the master cylinder pressure sensor observed on the intelligent tester changes when the brake pedal is depressed.
- OK:
- When the pedal is depressed, voltage displayed on the intelligent tester increases.
|
|
||||
| OK | |
| 3. READ VALUE USING INTELLIGENT TESTER (STOP LIGHT SWITCH) |
Select the "Data List" mode on the intelligent tester (Click here).
Data List: ABS/TRC/VSC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Stop Lamp SW
Stop light switch / ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
-
Check that the stop light condition observed on the intelligent tester changes when the brake pedal is depressed.
- OK:
- When the brake pedal is depressed, the intelligent tester displays "ON".
|
|
||||
| OK | |
| 4. RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTCs (Click here).
Start the engine.
At a speed of 30 km/h (18 mph) or more, drive the vehicle and perform braking test (decelerate the vehicle by depressing the brake pedal).
Check if the same DTC is recorded (Click here).
- HINT:
- Reinstall the sensors, connectors, etc. and restore the vehicle to its prior condition before rechecking for DTCs.
- Result:
Result
Proceed to
DTC (C1246/46) is not output
A
DTC (C1246/46) is output
B
|
|
||||
| A | ||
| ||
