Power Source Circuit
Circuit diagnosis · Vehicles built from Oct 2006
DESCRIPTION
This circuit supplies voltage from the battery to terminal B of the steering lock ECU. This circuit is used as power source for the steering lock CPU, motor, communication, and peripheral circuits.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - BODY GROUND) |
Disconnect the E51 connector from the steering lock actuator assembly.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E51-1 (GND) - Body ground
Always
Below 1 Ω
E51-2 (SGND) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - BATTERY) |
Measure the voltage according to the value(s) in the table below.

- Standard voltage:
Tester Connection
Condition
Specified Condition
E51-7 (B) - E51-1 (GND)
Always
10 to 14 V
E51-7 (B) - E51-2 (SGND)
Always
10 to 14 V
|
|
||||
| NG | ||
| ||
