Unlock Position Sensor Signal Circuit
Circuit diagnosis · Vehicles built from Oct 2006
DESCRIPTION
The unlock position sensor is one of the components in the steering lock actuator. The sensor switch contact closes when the steering lock is released. The steering lock release signal is then sent to the main body ECU. Receiving the signal, the ECU permits engine start. (This prevents the engine from being started with the steering locked.)WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU) |
Measure the voltage according to the value(s) in the table below.

- Standard voltage:
Tester Connection
Condition
Specified Condition
E51-4 (SLP1) - E51-2 (SGND)
- Engine switch off
- Engine switch on (ACC or IG)
Below 1 V
- Engine switch off
|
|
||||
| NG | |
| 2. CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - MAIN BODY ECU) |
Disconnect the E51 connector from the steering lock actuator assembly.

Disconnect the E7 connector from the main body ECU.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E51-4 (SLP1) - E7-18 (SLP)
Always
Below 1 Ω
E51-4 (SLP1) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
