2006-2011 Camry Aurion · Service Manual ENGINE

Engine Switch Indicator Circuit

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

Engine start conditions or system malfunctions can be checked by the status of the engine switch indicator light.
Engine switch indicator light condition: 
Power Source Mode/Condition
Indicator Light Condition
Brake pedal released
Brake pedal depressed, shift lever in P or N
off
OFF
ON (Green) (When key and vehicle IDs match)
on (ACC, IG)
ON (Amber)
ON (Green)
Engine running
OFF
OFF
Steering lock not unlocked
Flashes (Green) for 15 sec.
Flashes (Green) for 15 sec.
System malfunction
Flashes (Amber) for 15 sec.
Flashes (Amber) for 15 sec.

WIRING DIAGRAM

B157549E01

INSPECTION PROCEDURE


1. INSPECT ENGINE SWITCH

  1. Remove the engine switch.A109252E17

  1. Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.

    NOTICE:
    1. If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.
    2. If the voltage is too low, the indicator will not illuminate.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 11 (SWIL)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)
    Illuminates
    Battery positive (+) → Terminal 12 (INDS)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)
    Illuminates
    Battery positive (+) → Terminal 13 (INDW)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)
    Illuminates



NG
REPLACE ENGINE SWITCH (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (ENGINE SWITCH - MAIN BODY ECU AND BODY GROUND)

  1. Disconnect the E52 switch connector.B137980E13

  1. Disconnect the E7 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E52-11 (SWIL) - E7-25 (SWIL)
    Always
    Below 1 Ω
    E52-12 (INDS) - E7-15 (INDS)
    Always
    Below 1 Ω
    E52-13 (INDW) - E7-14 (INDW)
    Always
    Below 1 Ω
    E52-5 (GND) - Body ground
    Always
    Below 1 Ω
    E52-4 (COM) - Body ground
    Always
    Below 1 Ω
    E52-11 (SWIL) or E7-25 (SWIL) - Body ground
    Always
    10 kΩ or higher
    E52-12 (INDS) or E7-15 (INDS) - Body ground
    Always
    10 kΩ or higher
    E52-13 (INDW) or E7-14 (INDW) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU


← Engine does not Start (from Jun 2009)Engine Switch Indicator Circuit (from Jun 2009) →