Engine Switch Indicator Circuit
Circuit diagnosis · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
Engine start conditions or system malfunctions can be checked by the status of the engine switch indicator light.| Power Source Mode/Condition |
Indicator Light Condition |
|
| Brake pedal released |
Brake pedal depressed, shift lever in P or N |
|
| off |
OFF |
ON (Green) (When key and vehicle IDs match) |
| on (ACC, IG) |
ON (Amber) |
ON (Green) |
| Engine running |
OFF |
OFF |
| Steering lock not unlocked |
Flashes (Green) for 15 sec. |
Flashes (Green) for 15 sec. |
| System malfunction |
Flashes (Amber) for 15 sec. |
Flashes (Amber) for 15 sec. |
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT ENGINE SWITCH |
Remove the engine switch.


Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.
- NOTICE:
- If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.
- If the voltage is too low, the indicator will not illuminate.
- If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.
- OK:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 11 (SWIL)
Battery negative (-) → Terminal 4 (COM) or 5 (GND)
Illuminates
Battery positive (+) → Terminal 12 (INDS)
Battery negative (-) → Terminal 4 (COM) or 5 (GND)
Illuminates
Battery positive (+) → Terminal 13 (INDW)
Battery negative (-) → Terminal 4 (COM) or 5 (GND)
Illuminates
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (ENGINE SWITCH - MAIN BODY ECU AND BODY GROUND) |
Disconnect the E52 switch connector.


Disconnect the E7 ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E52-11 (SWIL) - E7-25 (SWIL)
Always
Below 1 Ω
E52-12 (INDS) - E7-15 (INDS)
Always
Below 1 Ω
E52-13 (INDW) - E7-14 (INDW)
Always
Below 1 Ω
E52-5 (GND) - Body ground
Always
Below 1 Ω
E52-4 (COM) - Body ground
Always
Below 1 Ω
E52-11 (SWIL) or E7-25 (SWIL) - Body ground
Always
10 kΩ or higher
E52-12 (INDS) or E7-15 (INDS) - Body ground
Always
10 kΩ or higher
E52-13 (INDW) or E7-14 (INDW) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
