2006-2011 Camry Aurion · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. DISCHARGE FUEL SYSTEM PRESSURE

HINT:
Click here.


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

  1. A144946E01
    Disconnect the mass air flow meter connector (*1).

  1. Disconnect the purge VSV connector (*2).

  1. Disconnect the 2 purge VSV vacuum hoses (*3).

  1. Disconnect the purge line hose from the clamp (*4).

  1. A146036
    Disconnect the No. 2 ventilation hose from the air cleaner hose.

  1. A135668
    Lock the No. 1 air cleaner hose clamp, and then disconnect the No. 1 air cleaner hose from the throttle body.

  1. A146037
    Remove the 2 bolts and air cleaner cap.

  1. Remove the air cleaner filter element from the air cleaner case.


4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

  1. A134904
    Remove the 2 nuts and cover.


5. DISCONNECT FUEL TUBE SUB-ASSEMBLY

  1. A136015E01
    Remove the No. 1 fuel pipe clamp.

    NOTICE:
    Check for foreign matter on the pipe and around the connector before disconnecting the quick connector. Clean the connector if necessary.

  1. A136016E01
    If the connector and pipe are stuck, pinch the connector, and push and pull the pipe to disconnect them.

    NOTICE:
    1. Do not use any tools in this procedure.
    2. Check for foreign matter on the sealing surface of the disconnected pipe. Clean it if necessary.

  1. A136017E01
    Separate the fuel tube sub-assembly from the fuel hose clamp.


6. DISCONNECT NO. 2 VENTILATION HOSE

  1. A147103
    Disconnect the No. 2 ventilation hose from the ventilation valve.


7. REMOVE FUEL DELIVERY PIPE WITH INJECTOR

  1. A147100
    Remove the 2 wire harness clamps.

  1. Disconnect the 4 fuel injector connectors.

  1. A147099
    Remove the 2 bolts, then remove the fuel delivery pipe together with the 4 fuel injectors.

    NOTICE:
    Be careful not to drop the fuel injectors when removing the fuel delivery pipe.

  1. A147098
    Remove the 2 delivery pipe spacers from the cylinder head.

  1. Remove the 4 insulators from the cylinder head.


8. REMOVE FUEL INJECTOR ASSEMBLY

  1. A097399E02
    Pull out the 4 injectors from the delivery pipe.

  1. Remove the 4 O-rings from the injectors.

← REMOVAL (Oct 2006 – May 2009)INSPECTION (from Jun 2006) →