2006-2011 Camry Aurion · Service Manual ENGINE

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

HINT:
  1. Use the following procedures to troubleshoot the push-button start function.
  2. The intelligent tester should be used in steps 4, 5 and 8.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS CHECK

      HINT:
      1. In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
      2. Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

      1. The following 5 items are important points in the problem analysis:
        What
        Vehicle model, system name
        When
        Date, time, occurrence frequency
        Where
        Road conditions
        Under what conditions?
        Running conditions, driving conditions, weather conditions
        How did it happen?
        Problem symptoms
    NEXT

    3.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    4.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM
    1. Use the intelligent tester to check if the CAN Communication System is functioning normally (for LHD: Click here), (for RHD: Click here)).

      Result:
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B


    B.
    A

    5.CHECK FOR DTC
    1. Check for DTCs and note any codes that are output (Click here).

    2. Delete DTCs.

    3. Recheck for DTCs.

      Result:
      Result
      Proceed to
      DTC does not reoccur
      A
      DTC reoccurs
      B


    B.
    A

    6.INSPECT BASIC OPERATION
    1. Turn the engine switch on (START) and check that the engine starts normally. Make sure that the brake pedal is depressed and the shift position is P at this time.

    2. Check that the engine switch mode can be changed by pushing the engine switch.

      HINT:
      Without depressing the brake pedal, push the engine switch repeatedly. Engine switch mode should turn from off to on (ACC) to on (IG) and back to off.
      With the brake pedal depressed, push the engine switch repeatedly. Engine switch mode should turn to ENGINE START from any status.

      OK:
      Engine can start normally.

    NEXT

    7.PROBLEM SYMPTOMS TABLE

      Result:
      Result
      Proceed to
      Fault is not listed in the problem symptoms table
      A
      Fault is listed in the problem symptoms table
      B


    B.
    A

    8.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU (Click here)

    2. DATA LIST/ACTIVE TEST (Click here)

    NEXT

    9.REPAIR OR REPLACE
      NEXT

      10.CONFIRMATION TEST
        NEXT

        ← HOW TO PROCEED WITH TROUBLESHOOTING (Oct 2006 – May 2009)PROBLEM SYMPTOMS TABLE (Oct 2006 – May 2009) →