Slip Indicator Light does not Come ON
Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
The skid control ECU is connected to the combination meter assembly via CAN communication.The SLIP indicator light blinks during VSC and/or TRC operation.
When the system fails, the SLIP indicator light comes on to warn the driver (Click here).
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Check the condition of each related circuit connector before troubleshooting (Click here).
| 1. CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
- Result:
Result
Proceed to
CAN communication system DTC is not output
A
CAN communication system DTC is output
B
|
|
||||
| A | |
| 2. INSPECT COMBINATION METER ASSEMBLY |
Connect the intelligent tester to the DLC3.
Select the "Active Test" on the tester (Click here).
Active Test: ABS/TRC/VSC Tester Display
Test Part
Control Range
Diagnostic Note
Slip Indicator Lamp
Slip indicator light
Indicator light ON/OFF
Observe combination meter
Check the SLIP indicator light operation.
- OK:
- The SLIP indicator light turns on or off in accordance with the intelligent tester.
|
|
||||
| OK | ||
| ||
