2006-2011 Camry Aurion · Service Manual TRANSMISSION

ADJUSTMENT

Removal / installation · Vehicles built from Jun 2006


1. ADJUST SHIFT LEVER POSITION
  1. Move the shift lever to the N position.

  1. C135109
    Remove the nut from the control shaft lever.

  1. Disconnect the transmission control cable assembly from the control shaft lever.

  1. C135711
    Push the control shaft fully downward.

  1. Return the control shaft lever 2 notches to the N position.

  1. C135734E02
    Move the slider in the directions indicated by arrow A and pull up the lock piece in the direction indicated by arrow B.

    NOTICE:
    Do not damage the boot.

  1. C135109
    Connect the transmission control cable assembly to the control shaft lever with the nut.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not damage the boot.

  1. C138300E01
    Push in the lock piece.

    NOTICE:
    Firmly push in the lock piece until the slider lock is engaged.

  1. Start the engine and make sure that the vehicle moves forward when moving the lever from the N to the D position and moves rearward when moving it to the R position.
    If it becomes hard to move the shift lever, readjust the shift lever position.

← INSPECTION (from Jun 2006)REASSEMBLY (from Jun 2006) →