Install the clutch accumulator assembly with the 2 nuts.
Torque:
12 N*m{
120 kgf*cm
, 9 ft.*lbf
}
2.
CONNECT CLUTCH LINE
Using SST, connect the clutch lines to the clutch accumulator assembly.
SST
09023-00101
Torque:
15 N*m{
155 kgf*cm
, 11 ft.*lbf
}
3.
INSTALL RELEASE CYLINDER HEAT INSULATOR
Install the release cylinder heat insulator with the 2 bolts.
Torque:
12 N*m{
120 kgf*cm
, 9 ft.*lbf
}
4.
INSTALL CLUTCH ACCUMULATOR BRACKET
Install the clutch accumulator bracket with the 2 bolts.
Torque:
Bolt A:
12 N*m{
120 kgf*cm
, 9 ft.*lbf
}
Bolt B:
37 N*m{
380 kgf*cm
, 28 ft.*lbf
}
5.
BLEED CLUTCH PIPE LINE
Fill the brake reservoir with brake fluid and bleed the clutch system.
Torque:
8.4 N*m{
86 kgf*cm
, 74 in.*lbf
}
6.
INSPECT BRAKE FLUID LEAKAGE
HINT:
Check for leakage in the clutch system.
7.
INSTALL AIR CLEANER CASE SUB-ASSEMBLY
Install the air cleaner case with the 3 bolts.
Torque:
5.0 N*m{
51 kgf*cm
, 44 in.*lbf
}
Connect the hose clamp.
8.
INSTALL AIR CLEANER CAP SUB-ASSEMBLY
Install the air cleaner filter element onto the air cleaner case.
Insert the hinges. Install the air cleaner cap sub-assembly with the 2 bolts.
Connect the No. 1 air cleaner hose to the throttle body and unfasten the No. 1 air cleaner hose clamp.
NOTICE:
Match each concave area concavity of the air cleaner hose with the bolt of the throttle body.
Make sure that the hose clamp is at the correct angle.
Connect the No. 2 ventilation hose to the air cleaner hose.
Connect the purge line hose to the clamp (*1).
Connect the 2 purge VSV vacuum hoses (*2).
Connect the purge VSV connector (*3).
Connect the mass air flow meter connector (*4).
9.
INSTALL AIR CLEANER INLET ASSEMBLY
Install the air cleaner inlet with the 2 bolts.
Torque:
5.0 N*m{
51 kgf*cm
, 44 in.*lbf
}
10.
INSPECT BRAKE FLUID LEVEL IN RESERVOIR
Check the fluid level. If brake fluid level is low, check for leakage and inspect the disc brake pad. If necessary, refill the reservoir with brake fluid after repair and replacement.