B2786 No Response from Steering Lock ECU
Diagnostic trouble codes · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
This DTC is output when the certification ECU does not receive LIN communication from the steering lock ECU for 10 seconds.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2786 |
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- If the certification ECU is replaced, register the key and ECU communication ID.
- If the certification ECU is replaced, register the key and ECU communication ID.
- If the steering lock ECU is replaced, register the ECU code and ECU communication ID.
- If the steering lock ECU is replaced, register the ECU code and ECU communication ID.
| 1. CHECK DTC OUTPUT |
Delete the DTCs (Click here).
Recheck for DTCs (Click here).
- Result:
Result
Proceed to
B2786 output recurs
A
B2786 output does not recur
B
|
|
||||
| A | |
| 2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - STEERING LOCK ECU) |
Disconnect the E58 and E51 ECU connectors.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Specified Condition
E58-10 (LIN) - E51-5 (LIN)
Below 1 Ω
E58-10 (LIN) - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 3. REPLACE CERTIFICATION ECU |
Replace the certification ECU.
| NEXT | |
| 4. ELECTRICAL KEY REGISTRATION |
Register the electrical key code in the certification ECU.
| NEXT | |
| 5. ECU COMMUNICATION ID REGISTRATION |
Register the ECU communication ID between the ID code box and ECM.
| NEXT | |
| 6. CHECK DTC OUTPUT |
Delete the DTCs (Click here).
Recheck for DTCs (Click here).
- Result:
Result
Proceed to
B2786 output recurs
A
B2786 output does not recur
B
|
|
||||
| A | ||
| ||
