2006-2011 Camry Aurion · Service Manual SECURITIES

B2791 Communication Condition Failure between ECM

Diagnostic trouble codes · Vehicles built Oct 2006 – May 2009

DESCRIPTION

This DTC is output when the ID code box does not respond to a verification request signal from the ECM.

HINT:
  1. If the engine switch is turned off immediately after the engine starts, DTC B2791 will be detected. If DTC B2791 is cleared, this DTC will not recur because it does not indicate a malfunction.
  2. If this DTC B2791 is detected simultaneously with DTC B2799, troubleshoot B2799 first.

DTC No.
DTC Detection Condition
Trouble Area
B2791
ID code box does not respond to a verification request signal from ECM
-

WIRING DIAGRAM

B150859E02

INSPECTION PROCEDURE

NOTICE:
If the engine can be started even when DTC B2791 is output, the ID code box can be considered normal. Be sure to recheck for DTCs after clearing the DTCs (Click here).


1. CHECK ENGINE START
  1. Delete the DTCs (Click here).

  1. Check that the engine starts.

    Result:
    Result
    Proceed to
    Engine does not start
    A
    Engine starts
    B

    HINT:
    Perform this step when the engine switch is turned off immediately after the engine starts.



B
END
A


2. CHECK DTC OUTPUT
  1. Recheck for DTCs (Click here).

    Result:
    Result
    Proceed to
    B2791 and other DTC output
    A
    No DTC output
    B

    HINT:
    If the engine does not start, DTC B2791 will not be detected separately from other DTCs because DTC B2791 will be output together with other DTCs. Troubleshoot DTCs other than DTC B2791.



B
GO TO SMART ENTRY AND START SYSTEM (Click here)
A

REPAIR CIRCUITS INDICATED BY OUTPUT DTCS


← B2790 ID BOX EEPROM Malfunction (from Oct 2006)B2799 Engine Immobiliser System Malfunction (Oct 2006 – May 2009) →