2006-2011 Camry Aurion · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

HINT:
  1. Use the same procedures for the RH side and the LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE FRONT WHEEL

2. REMOVE FRONT AXLE HUB NUT

  1. C108168E02
    Using SST and a hammer, release the staked part of the front axle hub nut.
    SST
    09930-00010  

    NOTICE:
    Loosen the staked part of the nut completely, otherwise the thread of the drive shaft may be damaged.

  1. While applying the brakes, remove the front axle hub nut.


3. SEPARATE FRONT SPEED SENSOR

  1. C140592
    Remove the bolt and clip, and separate the speed sensor wire and flexible hose from the shock absorber.

  1. C132782E01
    Remove the bolt and separate the speed sensor from the steering knuckle.

    NOTICE:
    1. Prevent foreign matter from adhering to the speed sensor.
    2. Be careful not to damage the speed sensor.


4. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY

  1. C067088E04
    Remove the 2 bolts and separate the front disc brake caliper assembly from the steering knuckle.

    NOTICE:
    Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.


5. REMOVE FRONT DISC

  1. C132801E01
    Remove the front disc.

    HINT:
    Put matchmarks on the disc and the axle hub.


6. SEPARATE TIE ROD END ASSEMBLY

  1. C108515E05
    Remove the cotter pin and nut.

  1. Using SST, separate the tie rod end sub-assembly from the steering knuckle.

    SST
    09628-00011  

    NOTICE:
    1. Make sure that the string of SST is securely tied to the vehicle.
    2. Be careful not to damage the ball joint dust cover.
    3. Be careful not to damage the steering knuckle.
    4. Be careful not to damage the front disc brake dust cover.


7. SEPARATE FRONT SUSPENSION LOWER NO. 1 ARM

  1. F040142E01
    Remove the bolt and 2 nuts, and separate the front suspension lower No. 1 arm from the lower ball joint.


8. REMOVE FRONT AXLE ASSEMBLY

  1. C129150E01
    Put matchmarks on the front drive shaft assembly and the front axle hub sub-assembly.

  1. Using a plastic hammer, separate the front drive shaft assembly from the front axle assembly.

    NOTICE:
    Be careful not to damage the drive shaft boot and speed sensor rotor.

  1. C132414
    Remove the 2 bolts, 2 nuts, and front axle assembly.


9. SEPARATE FRONT DISC BRAKE DUST COVER
  1. Secure the steering knuckle in a vise using aluminum plates.

  1. C145241
    Remove the 4 bolts and separate the front disc brake dust cover from the steering knuckle.


10. REMOVE FRONT LOWER BALL JOINT

  1. C145242
    Remove the cotter pin and nut.

  1. C145243E01
    Using SST, remove the front lower ball joint.
    SST
    09628-62011  

    NOTICE:
    1. Do not damage the dust cover of the ball joint.
    2. Do not damage the steering knuckle.

← REMOVAL (Oct 2006 – May 2009)INSPECTION (from Jun 2006) →