2006-2011 Camry Aurion · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

3. REMOVE FRONT WHEELS

4. SEPARATE STEERING INTERMEDIATE SHAFT ASSEMBLY

  1. C133501
    Secure the steering wheel with the seat belt in order to prevent rotation.

    HINT:
    This operation is useful to prevent damage to the spiral cable.

  1. C148636E01
    Remove the bolt and slide the steering intermediate shaft assembly.

    NOTICE:
    Do not separate the steering intermediate shaft assembly from the power steering link assembly.

  1. C148618E02
    Put matchmarks on the steering intermediate shaft assembly and the power steering link assembly.

  1. Separate the steering intermediate shaft assembly from the power steering link assembly.


5. SEPARATE TIE ROD END SUB-ASSEMBLY

  1. C108515E05
    Remove the cotter pin and nut.

  1. Using SST, separate the tie rod end sub-assembly from the steering knuckle.

    SST
    09628-00011  

    NOTICE:
    1. Make sure that the string of the SST is securely tied to the vehicle.
    2. Be careful not to damage the ball joint dust cover.
    3. Be careful not to damage the steering knuckle.
    4. Be careful not to damage the front disc brake dust cover.


6. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH

  1. C144426E02
    Remove the nut and separate the front stabilizer link assembly LH from the front stabilizer bar.

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.


7. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedures as for the LH side.


8. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
Refer to the instructions for removal of the engine assembly (Click here).


9. REMOVE NO. 1 FRONT STABILIZER BRACKET LH

  1. C132433
    Remove the 2 bolts and the No. 1 front stabilizer bracket LH from the front frame assembly.


10. REMOVE NO. 1 FRONT STABILIZER BRACKET RH

  1. C139011
    Remove the 2 bolts and the front No. 1 stabilizer bracket RH from the front frame assembly.


11. REMOVE NO. 1 FRONT STABILIZER BAR BUSHING
  1. Remove the 2 front No. 1 stabilizer bar bushings from the front stabilizer bar.


12. REMOVE FRONT STABILIZER BAR
← COMPONENTS (from Jun 2006)REMOVAL (Oct 2006 – May 2009) →