REMOVAL
Removal / installation · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
|
| 2.
PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
|
| 4.
SEPARATE STEERING INTERMEDIATE SHAFT ASSEMBLY
|
 |
- Secure the steering wheel with the seat belt in order to prevent rotation.
- HINT:
- This operation is useful to prevent damage to the spiral cable.
- Remove the bolt and slide the steering intermediate shaft assembly.
- NOTICE:
- Do not separate the steering intermediate shaft assembly from the power steering link assembly.
- Put matchmarks on the steering intermediate shaft assembly and the power steering link assembly.
Separate the steering intermediate shaft assembly from the power steering link assembly.
| 5.
SEPARATE TIE ROD END SUB-ASSEMBLY
|
 |
- Remove the cotter pin and nut.
Using SST, separate the tie rod end sub-assembly from the steering knuckle.
- SST
- 09628-00011
- NOTICE:
- Make sure that the string of SST is securely tied to the vehicle.
- Be careful not to damage the ball joint dust cover.
- Be careful not to damage the steering knuckle.
- Be careful not to damage the front disc brake dust cover.
| 6.
SEPARATE FRONT STABILIZER LINK ASSEMBLY LH |
 |
- Remove the nut and separate the front stabilizer link assembly LH from the front stabilizer bar.
- HINT:
- If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.
| 7.
SEPARATE FRONT STABILIZER LINK ASSEMBLY RH |
 |
- HINT:
- Perform the same procedures as for the LH side.
| 8.
REMOVE ENGINE ASSEMBLY WITH TRANSAXLE |
 |
- HINT:
- Refer to the instructions for removal of the engine assembly (Click here for 2AZ-FE, Click here for 2GR-FE).
| 9.
REMOVE NO. 1 FRONT STABILIZER BRACKET LH |
 |
- Remove the 2 bolts and the No. 1 front stabilizer bracket LH from the front frame assembly.
| 10.
REMOVE NO. 1 FRONT STABILIZER BRACKET RH |
 |
- Remove the 2 bolts and the front No. 1 stabilizer bracket RH from the front frame assembly.
| 11.
REMOVE NO. 1 FRONT STABILIZER BAR BUSHING |
 |
Remove the 2 front No. 1 stabilizer bar bushings from the front stabilizer bar.
| 12.
REMOVE FRONT STABILIZER BAR |
|