2006-2011 Camry Aurion · Service Manual SUSPENSION & AXLE

INSPECTION

Inspection · Vehicles built from Jun 2006


INSPECT REAR STABILIZER LINK ASSEMBLY

  1. C066721
    Inspect the turning of the ball joint.

    1. Secure the rear stabilizer link assembly in a vise using aluminum plates.

    2. Install the nut to the rear stabilizer link assembly stud.

    3. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

      Turning torque:
      0.05 to 1.0 N*m (0.5 to 10 kgf*cm, 0.4 to 8.9 in.*lbf)

      HINT:
      If the turning torque is not within the specified range, replace the rear stabilizer link assembly with a new one.

  1. Inspect the dust cover.

    1. Check that the dust cover is not cracked and that there is no grease on it.

      HINT:
      If there is any abnormality, replace the rear stabilizer link assembly with a new one.

← REMOVAL (from Oct 2006)INSTALLATION (Jun 2006 – Sep 2006) →