2006-2011 Camry Aurion · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Oct 2006

Versions by build date: Jun 2006 – Sep 2006 from Oct 2006

NOTICE:
If an old gasket still remains on the pipe, remove it. Also, if any bolts or nuts are rusted, replace them.


1. REMOVE REAR WHEELS

2. REMOVE CENTER EXHAUST PIPE ASSEMBLY (for 2AZ-FE)

  1. Remove the 2 bolts, 2 nuts and center exhaust pipe assembly.

    A146049

  1. Remove the gasket from the front exhaust pipe.


3. REMOVE TAIL EXHAUST PIPE ASSEMBLY (for 2GR-FE)

  1. Remove the 4 nuts and 2 exhaust tail pipes.

    A146044

  1. Remove the 2 gaskets from the exhaust tail pipes.


4. REMOVE CENTER EXHAUST PIPE ASSEMBLY (for 2GR-FE)

  1. Remove the 2 bolts, 2 nuts and exhaust center pipe assembly.

    A146045

  1. Remove the gasket from the exhaust front pipe assembly.


5. SEPARATE REAR STABILIZER LINK ASSEMBLY LH

  1. C144428E01
    Remove the nut and separate the rear stabilizer link assembly LH (lower side) from the rear stabilizer bar.

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud.


6. SEPARATE REAR STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedures as for the LH side.


7. REMOVE NO. 2 REAR STABILIZER BAR BRACKET

  1. C145565
    Remove the 2 bolts and No. 2 rear stabilizer bar bracket.


8. REMOVE NO. 1 REAR STABILIZER BAR BRACKET

  1. C145566
    Remove the 2 bolts and No. 1 rear stabilizer bar bracket.


9. REMOVE REAR STABILIZER BAR
  1. Remove the rear stabilizer bar with the stabilizer bushing.


10. REMOVE REAR STABILIZER BUSHING
  1. Remove the 2 rear stabilizer bushings from the rear stabilizer bar.

← REMOVAL (Jun 2006 – Sep 2006)INSPECTION (from Jun 2006) →