TERMINALS OF ECU
System information · Vehicles built Jun 2006 – May 2009
Versions by build date: Jun 2006 – May 2009 from Jun 2009
| CHECK MAIN BODY ECU (INSTRUMENT PANEL J/B) |
Disconnect the IF and IM, ID junction block connectors.
Disconnect the E7 and E9 main body ECU (instrument panel J/B) connectors.


Measure the resistance and voltage according to the value(s) in the table below.
*1: for LHDSymbols
(Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
GND1 (IF-10) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
GND2 (IM-9) - Body ground
BECU (ID-10) - Body ground
O - Body ground
Power source
Always
10 to 14 V
DCTY (E7-24) - Body ground
L*1 - Body ground
Y*2 - Body ground
Driver door courtesy light switch signal
Switch pushed (Door closed)
10 kΩ or higher
Switch free (Door opened)
Below 1 Ω
KSW (E9-5) - Body ground
B - Body ground
Key unlock warning switch signal
No key is in ignition key cylinder
10 kΩ or higher
Key is in ignition key cylinder
Below 1 Ω
*2: for RHD- HINT:
- If the result is not as specified, there may be a malfunction on the wire harness side.