2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

TERMINALS OF ECU

System information · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


CHECK MAIN BODY ECU (INSTRUMENT PANEL J/B)
  1. Disconnect the IF and IM, ID junction block connectors.

  2. Disconnect the E7 and E9 main body ECU (instrument panel J/B) connectors.
    B139183E01

  3. Measure the resistance and voltage according to the value(s) in the table below.

    Symbols
    (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    GND1 (IF-10) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    GND2 (IM-9) - Body ground
    BECU (ID-10) - Body ground
    BE - Body ground
    Power source
    Always
    10 to 14 V
    DCTY (E7-24) - Body ground
    L*1 - Body ground
    Y*2 - Body ground
    Driver door courtesy light switch signal
    Switch pushed (Door closed)
    10 kΩ or higher
    Switch free (Door opened)
    Below 1 Ω
    KSW (E9-5) - Body ground
    B - Body ground
    Key unlock warning switch signal
    No key is in ignition key cylinder
    10 kΩ or higher
    Key is in ignition key cylinder
    Below 1 Ω
    *1: for LHD
    *2: for RHD

    HINT:
    If the result is not as specified, there may be a malfunction on the wire harness side.

← TERMINALS OF ECU (Jun 2006 – May 2009)DIAGNOSIS SYSTEM (from Jun 2006) →