2006-2011 Camry Aurion · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


1. REMOVE FRONT WHEEL

2. REMOVE FRONT FENDER LINER (w/o Front Fender Mudguard)

  1. B149004
    Remove the 5 clips and bolt.

  1. Remove the 5 screws, grommet and the front fender liner.

    HINT:
    The grommet will break when it is removed. Replace the old grommet with a new one.


3. REMOVE FRONT FENDER MUDGUARD SUB-ASSEMBLY (w/ Front Fender Mudguard)

  1. B165397
    Remove the 3 screws and front fender mudguard sub-assembly.


4. REMOVE FRONT FENDER LINER (w/ Front Fender Mudguard)

  1. B141646
    Remove the 4 clips and bolt.

  1. Remove the 3 screws, grommet and the front fender liner.

    HINT:
    The grommet will break when it is removed. Replace the old grommet with a new one.


5. REMOVE FRONT SPEED SENSOR

  1. C143910E04
    Disconnect the front speed sensor connector and clamp.

  1. C132781E01
    Remove the 2 bolts from the body and the shock absorber assembly.

  1. Disengage the 2 claws from the steering knuckle.

  1. C144142
    Remove the bolt and the front speed sensor.

    NOTICE:
    1. Prevent foreign matter from attaching to the front speed sensor tip.
    2. Clean the installation hole and the surface for the front speed sensor every time the front speed sensor is removed.

← COMPONENTS (from Jun 2006)REMOVAL (Oct 2006 – May 2009) →