REMOVAL
Removal / installation · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
- HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
| 2.
REMOVE FRONT FENDER LINER (w/o Front Fender Mudguard) |
 |
- HINT:
- for 2AZ-FE (Click here).
- for 2GR-FE (Click here).
| 3.
REMOVE FRONT FENDER MUDGUARD SUB-ASSEMBLY (w/ Front Fender Mudguard) |
 |
- HINT:
- for 2AZ-FE (Click here).
- for 2GR-FE (Click here).
| 4.
REMOVE FRONT FENDER LINER (w/ Front Fender Mudguard) |
 |
- HINT:
- for 2AZ-FE (Click here).
- for 2GR-FE (Click here).
| 5.
REMOVE FRONT SPEED SENSOR |
 |
- Disconnect the front speed sensor connector and clamp.
- Remove the 2 bolts from the body and the shock absorber assembly.
Disengage the 2 claws from the steering knuckle.
- Remove the bolt and the front speed sensor.
- NOTICE:
- Prevent foreign matter from attaching to the front speed sensor tip.
- Clean the installation hole and the surface for the front speed sensor every time the front speed sensor is removed.