REMOVAL
Removal / installation · Vehicles built Jun 2006 – May 2009
Versions by build date: Jun 2006 – May 2009 from Jun 2009
- HINT:
- Use the same procedure for the RH side and LH side.
- The procedures listed below are for the LH side.
| 2.
DISCONNECT SKID CONTROL SENSOR WIRE |
 |
- Disconnect the connector from the skid control sensor.
- NOTICE:
- Be careful not to damage the skid control sensor.
| 3.
SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
|
 |
- Remove the bolt and separate the flexible hose from the shock absorber.
- Remove the 2 bolts and separate the rear disc brake caliper assembly.
- NOTICE:
- Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.
| 4.
REMOVE REAR DISC (for LHD)
|
 |
- Put matchmarks on the rear disc and the axle hub.
- Release the parking brake and remove the rear disc.
- HINT:
- If the disc cannot be removed easily, turn and press the shoe adjuster firmly until the wheel comes free.
| 5.
REMOVE REAR DISC (for RHD)
|
 |
- Put matchmarks on the rear disc and the axle hub.
- Release the parking brake and remove the rear disc.
- HINT:
- If the disc cannot be removed easily, turn and press the shoe adjuster firmly until the wheel comes free.
| 6.
REMOVE REAR AXLE HUB AND BEARING ASSEMBLY WITH SKID CONTROL SENSOR
|
 |
Disconnect the skid control sensor connector.
- Remove the 4 bolts and hub and bearing assembly.
| 7.
REMOVE SKID CONTROL SENSOR |
 |
- Mount the rear axle hub and bearing assembly in a vise using aluminum plates.
- NOTICE:
- Replace the rear axle hub and bearing assembly if it is dropped or receives a strong shock.
Using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments from SST.
- SST
- 09520-00031
(09521-00010, 09520-00040)
09521-00020
Using SST and 2 bolts (Diameter: 12 mm, pitch: 1.5 mm), remove the skid control sensor from the rear axle hub and bearing assembly.
- SST
- 09520-00031
(09521-00010, 09520-00040)
09521-00020
09950-00020
- NOTICE:
- Keep the skid control sensor away from magnets.
- Pull the skid control sensor off straight, taking care not to make contact with the skid control sensor rotor.
- If the skid control sensor rotor is damaged or deformed, replace the rear axle hub and bearing assembly.
- Do not scratch the contact surface between the rear axle hub and bearing assembly and the skid control sensor.
- Do not allow foreign matter to adhere to the skid control sensor rotor and tip.