2006-2011 Camry Aurion · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009

HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.
  3. The skid control sensor is a component of the rear axle hub and bearing assembly. If the skid control sensor needs to be replaced, replace the rear axle hub and bearing assembly.
  4. If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.


1. REMOVE REAR WHEEL

2. DISCONNECT SKID CONTROL SENSOR WIRE

  1. C143907
    Disconnect the connector from the skid control sensor.

    NOTICE:
    Be careful not to damage the skid control sensor.


3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

  1. C083014E02
    Remove the bolt and separate the flexible hose from the shock absorber.

  1. C138223
    Remove the 2 bolts and separate the rear disc brake caliper assembly.

    NOTICE:
    Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.


4. REMOVE REAR DISC

  1. C143446E02
    Put matchmarks on the rear disc and the axle hub.

  1. C131914E02
    Release the parking brake and remove the rear disc.

    HINT:
    If the disc cannot be removed easily, turn and press the shoe adjuster firmly until the wheel comes free.


5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY WITH SKID CONTROL SENSOR
  1. Remove the rear axle hub and bearing assembly with skid control sensor (Click here).

    HINT:
    1. The skid control sensor is a component of the rear axle hub and bearing assembly. If the skid control sensor malfunctions, replace the rear axle hub and bearing assembly.
    2. If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.

← REMOVAL (Jun 2006 – May 2009)INSPECTION (from Jun 2006) →