2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Headlight Leveling ECU Power Source Circuit

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

DESCRIPTION

This circuit detects the state of the ignition switch, and sends it to the headlight leveling ECU.

WIRING DIAGRAM

E133286E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (BATTERY - HEADLIGHT LEVELING ECU)

  1. E116070E05
    Disconnect the A20 headlight leveling ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A20-1 (IG) - Body ground
    Ignition switch on (IG)
    10 to 14 V
    A20-1 (IG) - Body ground
    Ignition switch off
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (HEADLIGHT LEVELING ECU - BODY GROUND)

  1. E116070E06
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A20-9 (E1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Taillight Relay Circuit (from Jun 2009)Height Control Sensor Circuit (Oct 2006 – May 2009) →