2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Height Control Sensor Circuit

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

DESCRIPTION

The headlight leveling ECU receives a signal from the rear height control sensor to detect the vehicle height.

WIRING DIAGRAM

B110605E04

INSPECTION PROCEDURE


1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY

  1. E121521E03
    Connect 3 dry cell batteries (1.5 V) in series.

  1. Remove the rear height control sensor sub-assembly.

  1. Connect the positive (+) lead from the battery to terminal 3, and the negative (-) lead from the battery to terminal 1.

  1. Measure the voltage between terminals 2 and 1 while slowly moving the link up and down.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    2 (SHRR) - 1 (SHG)
    +45° (High)
    Approx. 4.05 V
    0° (Normal)
    Approx. 2.25 V
    -45° (Low)
    Approx. 0.45 V



NG
REPLACE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY
OK


2. CHECK HARNESS AND CONNECTOR (ECU - REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY)

  1. E116038E03
    Disconnect the O23 rear height control sensor sub-assembly connector.

  1. Disconnect the A20 headlight leveling ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A20-12 (SBR) - O23-3 (SHB)
    Always
    Below 1 Ω
    A20-19 (SHRL) - O23-2 (SHRR)
    Always
    Below 1 Ω
    A20-21 (SGR) - O23-1 (SHG)
    Always
    Below 1 Ω
    A20-12 (SBR) - Body ground
    Always
    10 kΩ or higher
    A20-19 (SHRL) - Body ground
    Always
    10 kΩ or higher
    A20-21 (SGR) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Headlight Leveling ECU Power Source Circuit (Oct 2006 – May 2009)Headlight Beam Level Control Actuator Circuit (Oct 2006 – May 2009) →