Rear Power Window Motor LH Circuit
Circuit diagnosis · Vehicles built from Jun 2006
DESCRIPTION
This circuit transmits signals from the power window regulator switch assembly (Rear LH) to the power window regulator motor (Rear LH).WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT POWER WINDOW REGULATOR MOTOR |
Remove the power window motor.

Apply battery voltage to the motor connector according to the table below.
- NOTICE:
- Do not apply battery voltage to any terminals except terminals 1 and 2.
- OK:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
Motor gear rotates clockwise
Battery positive (+) → Terminal 2
Battery negative (-) → Terminal 1
Motor gear rotates counterclockwise
|
|
||||
| OK | |
| 2. CHECK WIRE HARNESS (WINDOW REGULATOR MOTOR - WINDOW REGULATOR SWITCH) |
Disconnect the K1 and K3 connectors.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
K1-4 (U) - K3-1
Always
Below 1 Ω
K1-1 (D) - K3-2
Always
Below 1 Ω
K1-4 (U) - Body ground
Always
10 kΩ or higher
K1-1 (D) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
