2006-2011 Camry Aurion · Service Manual BODY

Front Passenger Side Power Window Motor Circuit

Circuit diagnosis · Vehicles built from Jun 2006

DESCRIPTION

This circuit transmits signals from the power window regulator switch assembly (Front passenger) to the power window regulator motor (Front passenger).

WIRING DIAGRAM

B137065E20

INSPECTION PROCEDURE


1. INSPECT POWER WINDOW REGULATOR MOTOR

  1. B127536E02
    Remove the power window motor.

  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply battery voltage to any terminals except terminals 1 and 2.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Motor gear rotates clockwise
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    Motor gear rotates counterclockwise



NG
REPLACE POWER WINDOW REGULATOR MOTOR
OK


2. CHECK WIRE HARNESS (WINDOW REGULATOR MOTOR - POWER WINDOW REGULATOR SWITCH)

  1. B137066E05
    Disconnect the H6 (I9) and H4 (I4) connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    LHD models:
    Tester Connection
    Condition
    Specified Condition
    H6-4 (U) - H4-2
    Always
    Below 1 Ω
    H6-1 (D) - H4-1
    Always
    Below 1 Ω
    H6-4 (U) - Body ground
    Always
    10 kΩ or higher
    H6-1 (D) - Body ground
    Always
    10 kΩ or higher
    RHD models:
    Tester Connection
    Condition
    Specified Condition
    I9-4 (U) - I4-2
    Always
    Below 1 Ω
    I9-1 (D) - I4-1
    Always
    Below 1 Ω
    I9-4 (U) - Body ground
    Always
    10 kΩ or higher
    I9-1 (D) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Driver Side Power Window Motor Circuit (from Jun 2006)Rear Power Window Motor LH Circuit (from Jun 2006) →