Radio Receiver Power Source Circuit
Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 from Oct 2006
DESCRIPTION
This circuit provides power to the radio receiver.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT RADIO RECEIVER |
Disconnect the radio receiver connector.

Measure the resistance according to the value in the table below.
- Standard resistance:
Tester connection
Condition
Specified condition
F6-7 (GND) - Body ground
Always
Below 1 Ω
Measure the voltage according to the values in the table below.
- Standard voltage:
Tester connection
Condition
Specified condition
F6-4 (B) - F6-7 (GND)
Always
10 to 14 V
F6-3 (ACC) - F6-7 (GND)
Ignition Switch ACC
10 to 14 V
|
|
||||
| OK | ||
| ||
