Microphone Circuit between Microphone and Radio Receiver
Circuit diagnosis · Vehicles built from Jun 2009
DESCRIPTION
This circuit sends the microphone signal from the microphone to the radio receiver.It also supplies power source from the radio receiver to the microphone.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT RADIO RECEIVER |
Disconnect the radio receiver connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
F43-3 (MACC) - Body ground
Ignition switch on (IG)
4 to 6 V
Text in Illustration *1
Component without harness connected
(Radio Receiver)
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (MICROPHONE - RADIO RECEIVER) |
Disconnect the microphone and radio receiver connectors.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
w/ Sliding Roof Tester Connection
Condition
Specified Condition
Q15-4 (SNS2) - F43-1 (SNS2)
Always
Below 1 Ω
Q15-3 (Ml1+) - F43-2 (MIC+)
Always
Below 1 Ω
Q15-5 (MlC-) - F43-5 (MIC-)
Always
Below 1 Ω
Q15-1 (ACC) - F43-3 (MACC)
Always
Below 1 Ω
F43-1 (SNS2) - Body ground
Always
10 kΩ or higher
F43-2 (MIC+) - Body ground
Always
10 kΩ or higher
F43-5 (MIC-) - Body ground
Always
10 kΩ or higher
F43-3 (MACC) - Body ground
Always
10 kΩ or higher
F43-6 (SGND) - Body ground
Always
10 kΩ or higher
w/o Sliding Roof Tester Connection
Condition
Specified Condition
Q17-4 (SNS2) - F43-1 (SNS2)
Always
Below 1 Ω
Q17-3 (Ml1+) - F43-2 (MIC+)
Always
Below 1 Ω
Q17-5 (MlC-) - F43-5 (MIC-)
Always
Below 1 Ω
Q17-1 (ACC) - F43-3 (MACC)
Always
Below 1 Ω
F43-1 (SNS2) - Body ground
Always
10 kΩ or higher
F43-2 (MIC+) - Body ground
Always
10 kΩ or higher
F43-5 (MIC-) - Body ground
Always
10 kΩ or higher
F43-3 (MACC) - Body ground
Always
10 kΩ or higher
F43-6 (SGND) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
