2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Radio Receiver Power Source Circuit

Circuit diagnosis · Vehicles built from Jun 2009

DESCRIPTION

This circuit provides power to the radio and display assembly.

WIRING DIAGRAM

E196849E03

INSPECTION PROCEDURE


1. INSPECT RADIO AND DISPLAY ASSEMBLY
  1. Disconnect the F6 radio and display assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F6-7 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F6-4 (B) - F6-7 (GND)
    Always
    11 to 14 V
    F6-3 (ACC) - F6-7 (GND)
    Ignition switch on (ACC)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Speaker Circuit (from Jun 2009)COMPONENTS (Jun 2006 – Sep 2006) →