2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Stereo Component Amplifier Power Source Circuit

Circuit diagnosis · Vehicles built from Jun 2009

DESCRIPTION

This circuit provides power to the stereo component amplifier.

WIRING DIAGRAM

E193082E01

INSPECTION PROCEDURE


1. INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY
  1. Disconnect the F46 stereo component amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F46-10 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F46-5 (+B) - F46-10 (GND)
    Always
    11 to 14 V
    F46-12 (ACC) - F46-10 (GND)
    Ignition switch on (ACC)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F46-9 (AMP+) - F46-10 (GND)
    Ignition switch on (IG)
    11 to 14 V



NG
Go to step 3
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

3. CHECK HARNESS AND CONNECTOR
  1. Disconnect the F36 navigation receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F46-9 (AMP+) - F36-9 (AMP)
    Always
    Below 1 Ω
    F46-9 (AMP+) - Body ground
    Always
    10 kΩ or higher

    Result:
    Result
    Proceed to
    NG
    A
    OK
    (for 2GR-FE RHD)
    B
    OK
    (except 2GR-FE RHD)
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (for 2GR-FE RHD) (Click here)

C
REPLACE NAVIGATION RECEIVER ASSEMBLY (except 2GR-FE RHD) (Click here)
A

REPAIR OR REPLACE HARNESS OR CONNECTOR


← Microphone Circuit between Microphone and Navigation Receiver Assembly (from Jun 2009)Navigation Receiver Assembly Power Source Circuit (Jun 2006 – Sep 2006) →