DIAGNOSIS SYSTEM
Troubleshooting · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 from Oct 2006
| DESCRIPTION |
The power window control system data can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs.
| CHECK DLC3 |
![]() ![]() |
The ECU uses ISO 15765-4 communication. The terminal arrangement of the DLC3 complies with ISO 15031-3 and matches the ISO 15765-4 format.

Symbols (Terminal No.)
Terminal Description
Condition
Specified Condition
SIL (7) - SG (5)
Bus "+" line
During transmission
Pulse generation
CG (4) - Body ground
Chassis ground
Always
Below 1 Ω
SG (5) - Body ground
Signal ground
Always
Below 1 Ω
BAT (16) - Body ground
Battery positive
Always
10 to 14 V
CANH (6) - CANL (14)
CAN bus line
Ignition switch OFF*
54 to 69 Ω
CANH (6) - CG (4)
HIGH-level CAN bus line
Ignition switch OFF*
200 Ω or more
CANL (14) - CG (4)
LOW-level CAN bus line
Ignition switch OFF*
200 Ω or more
CANH (6) - BAT (16)
HIGH-level CAN bus line
Ignition switch OFF*
6 kΩ or more
CANL (14) - BAT (16)
LOW-level CAN bus line
Ignition switch OFF*
6 kΩ or more
- NOTICE:
- *: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the door.
- HINT:
- Connect the cable of the intelligent tester to the DLC3, turn the ignition switch to the ON position and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the tester.
- If communication is normal when the tester is connected to another vehicle, inspect the DLC3 of the original vehicle.
- If communication is still not possible when the tester is connected to another vehicle, the problem may be in the tester itself. Consult the Service Department listed in the tester's instruction manual.
| CHECK DIAGNOSIS (WITH JAM PROTECTION) |
![]() ![]() |
- HINT:
- If there is a malfunction in the pulse sensor, manually operating the power window switch will cause the power window switch light to blink.
Turn the ignition switch to the ON position.
Manually operate the power window master switch or power window switch on each door.
Check the blinking pattern of the AUTO light as shown in the illustration.


If pattern (A) is displayed, check wire harness or power window ECU.
If pattern (B) is displayed, check power window regulator motor or power window ECU.
If the normal pattern is displayed, replace the power window regulator master switch.

