HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Jun 2009
- HINT:
- Use the following procedure to troubleshoot the rear view monitor system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| |||||
| 3.INSPECT BATTERY VOLTAGE |
- Standard Voltage:
- 11 to 14 V
| |||||
| 4.PROBLEM SYMPTOM CONFIRMATION |
| Result |
Proceed to |
| Symptom does not occur |
A |
| Symptom occurs |
B |
|
|||||
| |||||
| 5.SYMPTOM SIMULATION |
| |||||
| 6.CHECK IF SAME SYMPTOM APPEARS IN AUDIO AND VISUAL SYSTEM |
Refer to Audio and Visual System (for radio and display type) (Click here).
Result Result
Proceed to
Symptom does not appear
A
Symptom appears
B
|
|||||
| |||||
| 7.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
Result Result
Proceed to
Fault is not listed in Problem Symptoms Table
A
Fault is listed in Problem Symptoms Table
B
|
|||||
| |||||
| 8.BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW |
Refer to Terminals of ECU (Click here).
| |||||
| 9.ADJUST, REPAIR OR REPLACE |
| |||||
| 10.CONFIRMATION TEST |
| |||||