INSPECTION
Inspection · Vehicles built from Jun 2006
| INSPECT POWER WINDOW REGULATOR MOTOR (FRONT RH) |
Apply battery voltage to the motor connector according to the table below.

- NOTICE:
- Do not apply battery voltage to any terminals except terminals 1 and 2.
- Standard:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
Motor gear rotates clockwise
Battery positive (+) → Terminal 2
Battery negative (-) → Terminal 1
Motor gear rotates counterclockwise
| INSPECT POWER WINDOW REGULATOR MOTOR (FRONT LH) |
without Jam protection:

Apply battery voltage to the motor connector according to the table below.- NOTICE:
- Do not apply battery voltage to any terminals except terminals 1 and 2.
- Standard:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 2
Battery negative (-) → Terminal 1
Motor gear rotates clockwise
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
Motor gear rotates counterclockwise
with Jam protection:

Apply battery voltage to the motor connector according to the table below.- NOTICE:
- Do not apply battery voltage to any terminals except terminals 1, 2, 4, 7 and 10.
- Standard:
Switch Condition
Measurement Condition
Specified Condition
Manual Operation
Battery positive (+) → Terminal 2 (B)
Battery negative (-) → Terminal 1 (E), 7 (DWN1)
Motor gear rotates counterclockwise
Battery positive (+) → Terminal 2 (B)
Battery negative (-) → Terminal 1 (E), 10 (UP1)
Motor gear rotates clockwise
Auto Operation
Battery positive (+) → Terminal 2 (B)
Battery negative (-) → Terminal 1 (E), 4 (AUTO), 7 (DWN1)
Motor gear rotates counterclockwise
Battery positive (+) → Terminal 2 (B)
Battery negative (-) → Terminal 1 (E), 4 (AUTO) 10 (UP1)
Motor gear rotates clockwise
| INSPECT POWER WINDOW REGULATOR MOTOR (REAR RH) |
Apply battery voltage to the motor connector according to the table below.

- NOTICE:
- Do not apply battery voltage to any terminals except terminals 1 and 2.
- Standard:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 2
Battery negative (-) → Terminal 1
Motor gear rotates clockwise
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
Motor gear rotates counterclockwise
| INSPECT POWER WINDOW REGULATOR MOTOR (REAR LH) |
Apply battery voltage to the motor connector according to the table below.

- NOTICE:
- Do not apply battery voltage to any terminals except terminals 1 and 2.
- Standard:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
Motor gear rotates clockwise
Battery positive (+) → Terminal 2
Battery negative (-) → Terminal 1
Motor gear rotates counterclockwise
