The Other Caller cannot Hear Your Voice, or Your Voice is too Quiet or Distorted
Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
INSPECTION PROCEDURE
| 1. CHECK CELLULAR PHONE |
 |
Check if the other caller can hear your voice properly.
- OK:
- Your voice can be heard correctly.
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 2. CHECK SETTINGS |
 |
- Check if the mute switch is not set to on.
- OK:
- Mute switch is not set to on.
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 3. CHECK SETTINGS |
 |
- Enter the "Handsfree Voice Quality Set" mode (Click here).
Check if the Send Voice Level is set to "0".
- HINT:
- The Send Voice Level can be set to 11 different levels, -5 to +5, with a 3 dB difference.
Check if the Send Voice Level is set to the minimum or maximum level.
- HINT:
- When the Send Voice Level is set to the minimum or maximum level, the sound may be distorted.
- NOTICE:
- "Voice Quality Type" should not be changed.
- OK:
- The Send Voice Level is set to "0".
|
NG |
 |
|
| SET SEND VOICE LEVEL TO "0" |
|
|
| OK |
|
 |
|
| 4. CHECK MICROPHONE (NAVIGATION CHECK MODE) |
 |
- Enter the "MICROPHONE & VOICE RECOGNITION CHECK" mode (Click here).
When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.
Push the recording switch and perform voice recording.
- HINT:
- Voice can be recorded up to 5 seconds.
Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.
- OK:
- All check results are normal.
|
NG |
 |
|
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE |
|
|
| OK |
|
 |
|
| REPLACE NAVIGATION RECEIVER ASSEMBLY |
|