INSPECTION
Inspection · Vehicles built from Jun 2006
| INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side) |
for seat belt warning (only G.C.C. countries):

Measure the resistance between terminals of the switch when the switch is operated.- HINT:
- This is the inspection procedure of the inner belt switch for the seat belt warning.
- The circuit of the seat belt warning or airbag system cannot be inspected by this procedure.
- This is the inspection procedure of the inner belt switch for the seat belt warning.
- Standard resistance:
Tester Connection
Condition
Specified Condition
1 - 3
The passenger seat is occupied, seat belt is unfastened
Below 1 Ω
1 - 3
The passenger seat is occupied, seat belt is fastened
10 kΩ or higher
