OPERATION CHECK
Troubleshooting · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 from Oct 2006
| CHECK WINDOW LOCK SWITCH |
![]() ![]() |
Check that the front passenger side power window and rear power window operations are disabled when the window lock switch of the power window master switch is pressed.
- OK:
- Front passenger side power window and rear power window operations are disabled.
Check that the front passenger side power window and rear power windows can be operated when the window lock switch is pressed again.
- OK:
- Front passenger side power window and rear power windows can be operated.
| CHECK MANUAL UP/DOWN FUNCTION |
Check that the driver side power window operates as follows:
- OK:
Condition
Master Switch
Switch Operation
Power Window
Ignition switch ON
Driver side
Pulled halfway up
UP (Closed)
Pushed halfway down
DOWN (Open)
Check that the power windows except the driver side power window operate as follows:
- OK:
Condition
Switch
Switch Operation
Power Window
- Ignition switch ON
- Window lock switch OFF
Passenger side
Pulled up
UP (Closed)
Pushed down
DOWN (Open)
Rear LH
Pulled up
UP (Closed)
Pushed down
DOWN (Open)
Rear RH
Pulled up
UP (Closed)
Pushed down
DOWN (Open)
- Ignition switch ON
| CHECK AUTO UP/DOWN FUNCTION |
Check that the driver side power window operates as follows:
- OK:
Condition
Master Switch
Switch Operation
Power Window
Ignition switch ON
Driver side
Pulled up fully
UP (Closed)
Pushed down fully
DOWN (Open)
| CHECK REMOTE MANUAL UP/DOWN FUNCTION |
Check that the power windows except the driver side power window operate as follows:
- OK:
Condition
Master Switch
Switch Operation
Power Window
- Ignition switch ON
- Window lock switch OFF
Passenger side
Pulled up
UP (Closed)
Pushed down
DOWN (Open)
Rear LH
Pulled up
UP (Closed)
Pushed down
DOWN (Open)
Rear RH
Pulled up
UP (Closed)
Pushed down
DOWN (Open)
- Ignition switch ON
| CHECK JAM PROTECTION FUNCTION |
![]() ![]() |
- NOTICE:
- The jam protection function can be activated when either the AUTO UP function or MANUAL UP function is used.
- Limbs, fingers or other body parts should not be used to test the jam protection function. Do not allow any body parts to get caught by the moving window or regulator.
- The jam protection function can be activated when either the AUTO UP function or MANUAL UP function is used.
- HINT:
- The jam protection function can be activated when either the AUTO UP function or MANUAL UP function is used with the ignition switch ON. The jam protection function can also be activated as long as the driver's door remains closed, within 45 seconds after the ignition switch is turned off.
Check the reversing distance.
Fully open the door glass.
Place a check jig measuring 4 to 10 mm (0.16 to 0.40 in.) thick near the window fully closed position.
When the door glass is closed using AUTO or MANUAL operation, check that the door glass goes down after contacting the check jig. The glass should go 200 to 240 mm away from the position where it contacted the check jig.
While the door glass is going down, verify that the window switch can not be used to make the glass go up.
Check the reversing distance.
Fully open the door glass.
Place a check jig measuring 200 to 250 mm (7.90 to 9.84 in.) thick near the window fully closed position.
When the door glass is closed using AUTO or MANUAL operation, check that the door glass goes down after contacting the check jig. The door glass should go 80 to 100 mm away from the position where it contacted the check jig.
While the door glass is going down, verify that the window switch can not be used to make the glass go up.


