ADJUSTMENT
Removal / installation · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
| 1. INSPECT SHIFT LEVER POSITION |
When shifting from the P to the R position with the ignition switch on (IG) and the brake pedal depressed, make sure that the shift lever moves smoothly and moves correctly into position.
Start the engine and make sure that the vehicle moves forward when shifting from the N to the D position and moves rearward when shifting to the R position.
If operation cannot be done as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.
| 2. ADJUST SHIFT LEVER POSITION |
Remove the cool air intake duct seal (Click here).
Remove the air cleaner inlet assembly (Click here).
Remove the air cleaner cap sub-assembly (Click here).
Remove the air cleaner case sub-assembly (Click here).
Remove the No. 1 air cleaner inlet (Click here).
Move the shift lever to the N position.
Remove the nut and transmission control cable from the control shaft lever.

Align the protrusions of the park/neutral position switch.

Move the slider in the direction indicated by arrow A and pull up the lock piece in the direction indicated by arrow B.

- NOTICE:
- Do not damage the boot.
Install the transmission control cable assembly to the control shaft with the nut.

- Torque:
- 13 N*m{ 133 kgf*cm , 10 ft.*lbf }
- NOTICE:
- If the control cable end is excessively pushed up, the shift lever cannot be adjusted.
- When tightening the nut, confirm that the control cable is properly stretched.
- If the control cable end is excessively pushed up, the shift lever cannot be adjusted.
Push in the lock piece.

- NOTICE:
- Firmly push in the lock piece until the slider lock is engaged.
Install the No. 1 air cleaner inlet (Click here).
Install the air cleaner case sub-assembly (Click here).
Install the air cleaner cap sub-assembly (Click here).
Install the air cleaner inlet assembly (Click here).
Install the cool air intake duct seal (Click here).
Start the engine and make sure that the vehicle moves forward when moving the lever from the N to the D position and moves rearward when moving it to the R position. If it becomes hard to move the shift lever, readjust the shift lever position.
