REMOVAL
Removal / installation · Vehicles built from Jun 2006
| 1. DRAIN POWER STEERING FLUID |
| 2. REMOVE FRONT WHEEL RH |
| 3. REMOVE ENGINE UNDER COVER RH |
| 4. REMOVE FRONT FENDER APRON SEAL RH |
| 5. REMOVE V-RIBBED BELT |
Using SST and a 19 mm socket wrench, loosen the V-ribbed belt tensioner arm clockwise, then remove the V-ribbed belt.

- SST
- 09216-42010
- NOTICE:
- Be sure to connect SST and the tools so that they are in line during use.
- When retracting the tensioner, turn it clockwise slowly for 3 seconds or more. Do not apply force rapidly.
- After the tensioner is fully retracted, do not apply more force than necessary.
- Be sure to connect SST and the tools so that they are in line during use.
| 6. DISCONNECT NO. 1 FLUID RESERVOIR TO PUMP HOSE |
Slide the clip and disconnect the No. 1 fluid reservoir to pump hose from the vane pump assembly.

| 7. DISCONNECT PRESSURE FEED TUBE ASSEMBLY (for LHD) |
Remove the union bolt and disconnect the pressure feed tube assembly from the vane pump assembly.

Remove the gasket from the pressure feed tube assembly.
| 8. DISCONNECT PRESSURE FEED TUBE ASSEMBLY (for RHD) |
Remove the union bolt and disconnect the pressure feed tube assembly from the vane pump assembly.

Remove the gasket from the pressure feed tube assembly.
| 9. DISCONNECT POWER STEERING FLUID PRESSURE SWITCH CONNECTOR |
Disconnect the power steering fluid pressure switch connector.

| 10. REMOVE VANE PUMP ASSEMBLY |
Using SST, loosen the 2 bolts and remove the vane pump assembly.

- SST
- 09249-63010
Remove the 2 bolts from the vane pump assembly.

