2006-2011 Camry Aurion · Service Manual STEERING

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2006


1. HOLD VANE PUMP ASSEMBLY

  1. C135230E01
    Using SST, hold the vane pump assembly in a vise.
    SST
    09630-00014   (09631-00132)


2. REMOVE POWER STEERING SUCTION PORT UNION

  1. C135231
    Remove the bolt and power steering suction port union from the vane pump assembly.

  1. Using a screwdriver, remove the O-ring from the power steering suction port union.


3. REMOVE POWER STEERING FLUID PRESSURE SWITCH

  1. C133180
    Remove the power steering fluid pressure switch from the vane pump assembly.

    NOTICE:
    Perform this procedure only when the power steering fluid pressure switch is replaced.


4. REMOVE FLOW CONTROL VALVE ASSEMBLY

  1. C132033
    Remove the pressure port union.

  1. Remove the O-ring from the pressure port union.

  1. Remove the flow control valve assembly and the flow control valve compression spring.


5. REMOVE VANE PUMP REAR HOUSING

  1. C107024
    Remove the 4 bolts and vane pump rear housing from the vane pump front housing.

  1. C107025E02
    Using a screwdriver, remove the O-ring from the vane pump rear housing.

    HINT:
    Tape the screwdriver tip before use.


6. REMOVE VANE PUMP SHAFT WITH PULLEY

  1. C057767
    Using 2 screwdrivers, remove the vane pump shaft snap ring from the vane pump shaft with pulley.

  1. Remove the vane pump shaft with pulley.


7. REMOVE VANE PUMP ROTOR

  1. C114697
    Remove the 10 vane pump plates.

  1. Remove the vane pump rotor.


8. REMOVE VANE PUMP CAM RING

  1. C114698
    Remove the vane pump cam ring from the vane pump front housing.


9. REMOVE VANE PUMP FRONT SIDE PLATE

  1. C114699
    Remove the vane pump front side plate from the vane pump front housing.

  1. C107029E02
    Using a screwdriver, remove the O-ring from the vane pump front side plate.

    HINT:
    Tape the screwdriver tip before use.

  1. C114700
    Remove the O-ring from the vane pump front housing.


10. REMOVE VANE PUMP HOUSING OIL SEAL

  1. C114701E02
    Using a screwdriver and a shop rag or a piece of cloth, remove the vane pump housing oil seal.

    NOTICE:
    Be careful not to damage the vane pump front housing.

← REMOVAL (from Jun 2006)INSPECTION (from Jun 2006) →