2006-2011 Camry Aurion · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built Jun 2006 – May 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


CHECK ACCELERATOR PEDAL ASSEMBLY

  1. Measure the voltage.

    1. B139188E09
      Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to the ON position.

    3. Turn the intelligent tester on.

    4. Select the menu items: Powertrain / Engine and ECT / Data List / Accelerator Position No. 1 and Accelerator Position No. 2.

    5. Operate the accelerator pedal, and then check that the Accelerator Position No. 1 and Accelerator Position No. 2 values are within the specifications.

      Standard voltage (Accelerator Position No. 1):
      Accelerator Pedal Condition
      Specified Condition
      Released
      0.5 to 1.1 V
      Depressed
      2.5 to 4.5 V

      Standard voltage (Accelerator Position No. 2):
      Accelerator Pedal Condition
      Specified Condition
      Released
      1.2 to 2.0 V
      Depressed
      3.4 to 5.0 V

      If the result is not as specified, check the accelerator pedal assembly, wire harness or ECM.

← COMPONENTS (from Jun 2006)ON-VEHICLE INSPECTION (from Jun 2009) →