ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – May 2009 from Jun 2009
| CHECK ACCELERATOR PEDAL ASSEMBLY |
Measure the voltage.
Connect the intelligent tester to the DLC3.

Turn the ignition switch on (IG).
Turn the intelligent tester on.
Select the menu items: Powertrain / Engine and ECT / Data List / Accelerator Position No. 1 and Accelerator Position No. 2.
Operate the accelerator pedal, and then check that the Accelerator Position No. 1 and Accelerator Position No. 2 values are within the specifications.
- Standard voltage (Accelerator Position No. 1):
Accelerator Pedal Condition
Specified Condition
Released
0.5 to 1.1 V
Depressed
2.5 to 4.5 V
- Standard voltage (Accelerator Position No. 2):
Accelerator Pedal Condition
Specified Condition
Released
1.2 to 2.0 V
Depressed
3.4 to 5.0 V
